kascewellness.blogg.se - Cms ip camera software mac

CMS IP CAMERA SOFTWARE MAC UPDATE
CMS IP CAMERA SOFTWARE MAC SOFTWARE

CMS IP CAMERA SOFTWARE MAC SOFTWARE

The management software can manage Max 96 front end network monitoring devices can set and control any device, and other functions can support 1/4/6/8/9/16/25/36 pictures display on one screen, and two way voice talk back, logs retrieval, and other functions. Sync switch would rely on an external sensor to change the day/night mode, which your camera doesn’t have.2 foreword The CMS of IP Camera is used to realize all front end network video monitoring devices(including network video server, IP camera) centralized monitoring, storage, management and control. Auto switch uses the light conditions to set the camera to decide when to switch to night mode.

Wide Dynamic – Improves lightning dynamic range, but can trade off colour and can introduce noise in lower light conditions.

A ‘strong’ slow shutter relates to a longer exposure. Setting to ‘None’ decreases motion blur, but will allow less light in to the camera.

Slow Shutter – Slows down the shutter speed.

Scene mode relates to how the camera behaves with artificial light.

‘BlackWhite’ is always in night mode – always using infrared light, not visible light.

‘MultiColor’ is always in day mode – not utilising camera infrared light.

Day/Night mode – Set whether camera automatically switches between Day or Night mode with menu ‘DNAutoOper’.

Some of the settings are explained below: If you find that you need to change any settings, go to ‘device config’ and then ‘Camera Param’. If multiple events occur within this delay time, the video will continue, until the last event trigger.Īll of the cameras we sell will have preset parameters that will be suitable for most applications and usually won’t need to be amended. If just one event is triggered, the video will last for the length of the delay time. If a 2 second interval is set, any movements would not be ignored within the two seconds after an initial trigger.

Interval: Sets the time between when triggers can occur.

It’s probably best practice to not use this setting, as you can change the overall schedule, covered in the *** section.

Period: Sets the time that motion should be active.

A lower sensitivity means that a lot of the pixels on the screen have to change to cause an event, with a higher sensitivity picking up much smaller pixel changes. The camera detects pixel changes, so light changes can trigger motion recording.

Sensitivity: How much ‘movement’ has to occur to trigger a motion event.

The default settings are usually fairly good to get you going, but here is a quick overview of what some of the settings change:

You can fine tune the motion settings here.

Go to the ‘Video Detect’ Menu and put a tick in the ‘Enable’ box.

CMS IP CAMERA SOFTWARE MAC UPDATE

Click ‘apply’ to update any settings changes. By default, its set as 00:00 to 23:59, which is 24 hours a day. You can also set a schedule in the time section for when you want recording events to occur. To enable this, navigate to ‘device config’, then select your camera on the left hand side.Įnter the ‘record config’ menu and ensure that there is a tick in the ‘detect’ box. If your camera has a built in SD card reader, you can set up motion recording to capture events of interest, rather than sifting through hours of continuous footage.